These are very popular motor drivers and for very good reason.  2A current, up to 36V supply.  5V logic. Extremely easy to interface with using…

Dual E3D V6 (and clones) hotend mount for the Prusa I3.   Marlin firmware for the printer pictured available in git – contact for the link. …

*** 12-PACK *** 40 Pin female header, 2 rows of 20 pins each.  2.54mm / 0.1″ spacing This header has extra long pins which is why…

*** 2 Pack *** Arduino-compatible Buzzer/Beeper/Alarm module Active on low level (connect input pin to GND / LOW signal) Please consider taking advantage of our multi-item…

*** 2 Pieces *** ESP-8266 Development Board (commonly referred to as “NodeMCU”) USB-programmable (requires a microUSB cable); no extra programming device required. Built around the…

*** Includes male pins – Requires Soldering  *** Arduino Mega 2560 Compatible development board Features: ATmega2560 Microcontroller Built-in USB support for power and programming Power…

Includes Mini USB and Dupont wires pictured. Specs: ARM Cortex M3 @ 72MHz 20k RAM 32khz RTC crystal JTAG / ST-Link connector 8-pin 0.96″ OLED…

6-Camera Panorama Rig (360 Rig) designed for the GoPro Hero4 Uses standard GoPro waterproof housings, mounted with our custom backplates which are affixed to the…

3-PACK ESP32 ESP-WROOM-32 Development Board Powerful 32-Bit microcontroller with built-in Bluetooth 4.0 (BLE) and 2.4GHz WiFi With Pre-soldered breadboard headers and built-in USB-serial adapter, all you…

Microcontroller development board features:  ATTINY85 MCU On-board voltage regulator, power via USB or external 3 PWM pins Built-In USB Plugs directly into a USB port,…