6-Camera Panorama Rig (360 Rig) designed for the GoPro Hero4 Uses standard GoPro waterproof housings, mounted with our custom backplates which are affixed to the…

ESP-8266 Development Board (commonly referred to as “NodeMCU”) USB-programmable (requires a microUSB cable); no extra programming device required. Built around the extremely capable ESP8266 chip…

3.5″ Touchscreen display for Raspberry Pi 2 and 3 This is the perfect display if you want to keep the size as close to the…

Pack of 20 (Twenty) threaded inserts. These create much more convenient and professional parts than using “captive nuts” (where you have to design a slot…

This is essentially an Arduino Mega 2560 scaled down to 36.5×51.5mm (drasically smaller than the standard version). Since the USB port was removed to save…

Assortment of the most common sizes of our threaded inserts in Imperial  (Inch) sizes. A great starting point for taking your 3D printed products to…

E3D V6 clone hotend for direct-drive extruder NOT FOR BOWDEN CONFIGURATION Installation typically requires custom printer modifications – please understand what will be required before purchasing. …

*** 12-PACK *** 40 Pin female header, 2 rows of 20 pins each.  2.54mm / 0.1″ spacing This header has extra long pins which is why…

*** 2 Pack *** Pressure transducer with G1/4 Threads Input 5VDC Output: 0.5-4.5VDC Material: Steel Working pressure: 0-1.2MPa (approximately 0-174psi) Maximum pressure 2.4MPa Working temp.: 0-85C…

This sensor is similar to the /BX model, but more versatile due to supporting NC or NO (Normally Closed or Normally Open)configurations.  There are 4 wires…