Dual E3D V6 (and clones) hotend mount for the Prusa I3.   Marlin firmware for the printer pictured available in git – contact for the link. …

We added 4 more cameras to the Ultra360 rig for greater flexibility stitching complicated scenes, especially when the rig is close to objects.  We also…

40 Pin female header, 2 rows of 20 pins each.  2.54mm / 0.1″ spacing This header has extra long pins which is why it is…

Package of springs commonly used in 3D Printer extruders Can help to restore pressure between the feed device and the filament, improving filament extrusion. These…

*** 2 Pack *** New stepper motor cable for the most common NEMA 17 steppers found on 3D printers. Length is great for swapping to…

This listing is for the ballnut housing only – the ballnut, ballscrew, bearings, etc are not included. This is the piece that fits over the…

3-PACK ESP32 ESP-WROOM-32 Development Board Powerful 32-Bit microcontroller with built-in Bluetooth 4.0 (BLE) and 2.4GHz WiFi With Pre-soldered breadboard headers and built-in USB-serial adapter, all you…

Quantity 20 Socket Head Cap Screw 18-8 Stainless Steel FREE Shipping to the USA + APO Addresses 10% off 3, 15% off 5 items.  Applies to…

ALL – METAL (No PTFE/Teflon tube) throat for E3D V6 hotend and clones Great to have around as spares since these do eventually wear out/clog.  Replaces…

16-Channel PWM “shield” with I2C interface. Check out our store for other motion control components – don’t forget your LS7366 chip(s) if you are doing…